Interprotect White 750ml Osmosis Protection Primer

• An epoxy polyamide primer that can be recoated with itself for up to 6 months
• Easy to sand and quick to dry
• Good abrasion resistance
• Quick drying, easy to apply epoxy primer for high performance protection.
• Excellent anticorrosive protection
• Antifouling tie­coat for use over epoxy primers
• Good abrasion resistance
• Some Important Points Do not use below 5°C.
• Do not apply over conventional (one­pack) coatings.
• Do not apply when there is a chance of condensation forming on the substrate.
• Ambient temperature should be minimum 5°C/41°F and maximum 35°C/95°F. Product temperature should be minimum 10°C and maximum 35°C.
• Substrate temperature should be minimum 5°C/41°F and maximum 35°C/95°F.

Interprotect is a high performance two pack primer/undercoat. It’s perfectly formulated for polyester, vinylester, epoxy, steel, aluminium, ferro cement and timber hulls, above and below the waterline.

Compatibility/Substrates Interprotect can be used on all suitably prepared substrates and epoxy primers. Suitable for stainless steel trim tabs and stern drive gear. It should not be used over any one pack products.

Not suitable for use on bronze or mixed alloy propellers.

Number of Coats 1­5 by brush/roller depending on substrate and use Coverage (Theoretical) ­9.1 m²/L per coat by brush (Practical) ­8.1 m²/L per coat by brush

The purchaser is responsible for choosing the correct product for its particular application.